Filter
Top Products
PROGRAMMING
ELECTRONIC PROGRAMMABLE OPTIONS
To change the electronic options turn the ignition on, wait at least (1) second, and press the override/program button 5
times. You will hear one 2 second long confirmation chirp from the siren. Within the next 5 seconds press the
override/program button again the number of times that corresponds to the feature list below. The siren will chirp once
for each button press. Press the #2 Unlock button on the transmitter to change the option from the default factory
setting. 2 chirps will also be heard. If the #1 Lock button is pressed, the option will change the option back to the
original default setting and 1 siren chirp will sound.
PROGRAMMING OPTIONS CHART
Option #
Option Description Selection Fac. Pre-set
1 Double Unlock Pulse ON or OFF. OFF
2 Disarm with trunk pop ON or OFF OFF
3 Lights on with disarm ON or OFF ON
4 Active Carjack Enable ON or OFF OFF
5 10/60 Sec. Door Open
Warning
Button #1 = 10 Sec.
Button #2 = 60 Sec.
10 Sec.
6 Silent Arm/Disarm ON or OFF OFF
7 Active Re-Arm ON or OFF ON
8 Passive Carjack Enable ON or OFF OFF
OPTION DESCRIPTIONS (SEE CHART ABOVE)
DOUBLE UNLOCK PULSE
The unit will send 2 unlock pulses when the #2 Unlock button is pressed. This feature may be required for interfacing
this alarm with an existing Factory Keyless Entry or Alarm system in a vehicle. These systems are found on some
Nissan, VW, Toyota, and Lexus vehicles. Factory Default setting is OFF
DISARM WITH AUX. OUTPUT 1
This feature controls whether the system will or will not disarm when the trunk pop or Aux. feature is used. When the
feature is turned on the unit will disarm upon pressing Button #3 (Trunk Pop). Factory Default setting is OFF
LIGHTS ON WITH DISARM
Keeps parking lights on when system is disarmed to assist in locating your vehicle in a crowded parking lot or
structure. Light will stay on for 30 Sec. or until Ignition is turned on. Factory Default setting is ON.
CARJACK ENABLE
Enables Active Carjack protection features. Factory Default is OFF.
7