Filter
Top Products
OPERATION
DEFECTIVE ZONE ALERT/BYPASS
If the system detects a faulty or open zone (Door left open) when the system is armed, the siren will chirp 4 times
along with 4 light flashes. The faulty zone will be automatically bypassed.
AUTOLOCK/UNLOCK
The doors will automatically lock when the ignition is turned on and will unlock when the ignition is turned off. Doors
will not lock if they are open to prevent locking the keys in.
ACTIVE RE-ARMING (FAIL-SAFE PROTECTION)
Active Re-arming means that the system will re-arm itself 30 seconds after disarmed with the transmitter if a door has
not been opened. This is handy if the vehicle is accidentally disarmed without you knowing it. This feature can also be
turned off in programming option (7).
2
nd
AUX. OUTPUT (REMOTE AUX. OUTPUT 2)
To activate the Second auxiliary output press Button #1 (Lock) and hold for more than (1) second. This output can be
used to control other optional add-on accessories such as Remote Engine Start Modules, Window Roll up/down
modules, etc.
2 VEHICLE CONTROL
This unit can be programmed to Arm/Disarm a second vehicle with a CS-2001 system installed. Follow the steps for
transmitter programming on a second vehicle using Button #4 (Panic) from the existing remote . This will provide
arm/disarm control of a second vehicle with the same transmitter using button#4.
CARJACK PROTECTION
ACTIVE CARJACK
This feature provides Active Carjack protection and must be enabled before use through Alarm programming option (4)
See page 6. When the Ignition is on (vehicle is running), press and release button #4 (Panic). Parking lights will turn
on for (3) seconds to confirm the Carjack countdown sequence. 90 Seconds later, the unit will begin a Carjack Cycle
consisting of 10 seconds of pre-warning chirps turning into a full system activation with siren/flashing light pulses for up
to 5 min. To reset Active Carjack, press Button #4 again.
PASSIVE CARJACK
This feature provides Passive Carjack protection and must be enabled before use through Alarm programming option
(8). See page 6. This mode should only be considered in serious conditions. When the Ignition is on (vehicle is
running), if a door is opened the Carjack countdown sequence will be initiated. There is no confirmation that this has
begun. 90 Seconds later, the unit will begin a Carjack Cycle consisting of 10 seconds of pre-warning chirps turning into
a full system activation with siren/flashing light pulses for up to 5 min. To reset Passive Carjack, press the
override/program button (3) times.
11