Filter
Top Products
General System Functions General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The dual
button configuration allows for keyless entry and/or remote start functionality as well as a few other
functions. Although other CompuStar PRO systems have numerous button functions and capabilities,
please keep in mind that your system has the option for future upgradeability to a 2-way system with a
liquid crystal display.
The remote transmitter functions have been predetermined and programmed from the factory. The dual
button configuration allows for keyless entry and/or remote start functionality as well as a few other
functions. Although other CompuStar PRO systems have numerous button functions and capabilities,
please keep in mind that your system has the option for future upgradeability to a 2-way system with a
liquid crystal display.
Sending Commands Sending Commands
When in range, and the button has been pressed, the remote will beep, bright blue LED will illuminate,
and vehicle’s parking lights will flash. For example, to send a remote start command from the
P2BSHLEDR, hold down the key/start button for 2.5 seconds. The remote will beep and bright blue LED
will come on solid and then flash.
When in range, and the button has been pressed, the remote will beep, bright blue LED will illuminate,
and vehicle’s parking lights will flash. For example, to send a remote start command from the
P2BSHLEDR, hold down the key/start button for 2.5 seconds. The remote will beep and bright blue LED
will come on solid and then flash.
Receiving Commands Receiving Commands
The remote pager will receive beep and bright blue LED flash confirmation indicating confirmation of
sending commands. For example, after sending the lock command, the pager will be beep and flash the
LED once to confirm the vehicle has been successfully locked/armed.
The remote pager will receive beep and bright blue LED flash confirmation indicating confirmation of
sending commands. For example, after sending the lock command, the pager will be beep and flash the
LED once to confirm the vehicle has been successfully locked/armed.
Active Lock/Arm and Unlock/DisarmActive Lock/Arm and Unlock/Disarm
Tap the lock/unlock button for 0.5 seconds to lock/arm and unlock/disarm. The remote bright
blue LED will flash twice indicating the signal has been sent to the vehicle. Upon confirmation of
lock/arm or unlock/disarm the remote will beep and flash the LED once or twice respectively. This feature
is optional and may require additional programming and/or installation. Please check with your dealer for
details.
Automatic Transmission Remote Start Function
Hold the key/start button for 2.5 seconds to remote start an automatic transmission vehicle. If you are in
range and if the vehicle is ready to remote start, the vehicle parking lights will flash once. The remote will
beep once to confirm proper remote starting and then 4 times if unlocked/disarmed. (6 times if
locked/armed)
If you are in range, the parking lights on the vehicle will flash three times followed by a certain number
after that, there is a remote start error. Refer to the “remote start error diagnostic” on the last page of this
manual for details. The remote will beep 3 times followed by 2 LED flashes.
Upon receiving confirmation that your vehicle is running, the parking lights will light solid. The LED on the
remote will flash every other second to represent remote start run time. The remote-start run-time can be
programmed for 3, 15, 25, or 45 minutes - ask your local CompuStar dealer to adjust Option 2-7 if you
would like a run-time other than 15 minutes (default).
IMPORTANT: The vehicle’s key must be inserted into the ignition and turned to the “on” position prior to
driving your vehicle. If the foot brake is depressed prior to the key being in the “on” position, the vehicle
will shut off.
Manual Transmission Remote Start Function (Reservation Mode)
In order to remote start a manual transmission vehicle, the system must first be set in Reservation Mode.
Reservation Mode must be set each and every time you want to remote-start a manual transmission
vehicle. The purpose of Reservation Mode is to leave the transmission in neutral before exiting the
vehicle.
5