Filter
Top Products
Quick Reference Quick Reference
Valet ModeValet Mode
When servicing or loaning your vehicle to others, the CompuStar Pro system should be placed in Valet
mode. Valet mode prevents the system from remote starting and disables all alarm functions.
IMPORTANT: While in Valet mode the CompuStar Pro will still lock and unlock power lock systems.
The system can be put into valet one of three ways;
1. Turn the vehicles key to the ignition “on” position and tap lock/unlock and key/start buttons
simultaneously for 0.5 seconds. The parking lights will flash once and the remote will beep and
LED flash once to confirm the system is in valet mode. Repeat this process to take the system
out of valet mode. The parking lights will flash twice and remote will beep twice and LED flash
twice to confirm the system is out of valet mode.
2. You can put the system into valet by turning the ignition key “on” and then “off” five
times within 7 seconds. The parking lights will flash once to confirm the system is in
valet mode. Shortly after the first flash, the parking lights will flash twice.
3. (Optional Feature) If your system is set up for a secure valet option, you will not be able to put the
system into valet until the proper code has been entered with the secure valet switch.
Remote Maintenance – Battery Replacement
The only regular maintenance this system requires is remote control battery replacement.
No programming is required when replacing the battery.
Two-Way Remote: Pro 2BSHLEDR
First, remove the two small screw covers and Phillips screws located on the back of the remote. Once
the screws have been removed, gently pull the remote apart being careful to not touch the circuit board.
The P2BSHLEDR requires two CR2025 batteries. These specialty batteries can be purchased from your
local CompuStar dealer or an electronics store.
2 Button Remote Functions
Button Duration
Additional
Programming
Required
Function / Description
0.5
seconds
no Lock/Arm. Tap again to Unlock/Disarm the vehicle
2.5
seconds
no
Trunk pop. Triggers the trunk release output and opens the
vehicles trunk.
0.5
seconds
yes, POC
programming
Aux 1. Triggers the auxiliary 1 output (most commonly used for
rear defrost or window roll-down).
2.5
seconds
no Activates the remote start. Repeat and remote start will shut off.
0.5
seconds
no Valet mode (see above for details)
+
2.5
seconds
no Panic mode. Honks horn and flashes parking lights. (Optional)
4