Filter
Top Products
Quick Reference Quick Reference
Valet ModeValet Mode
When servicing or loaning your vehicle to others, the CompuStar Pro system should be in Valet mode.
Valet mode prevents the system from remote starting and disables all alarm functions.
IMPORTANT: While in Valet mode the CompuStar will still lock and unlock power lock systems. The
parking lights will not flash.
The system can be put into valet one of two ways;
1. Turn the vehicles key to the ignition “on” position and tap buttons
simultaneously for 0.5 seconds. The parking lights will flash once and/or siren chirp once to
confirm the system is in valet mode. Repeat this process to take the system out of valet mode. The
parking lights will flash twice and/or siren chirp once to confirm the system is out of valet mode.
2. If you don’t have your remote control, you can put the system into valet by turning the ignition key “on”
and then “off” five times within 7 seconds. The parking lights will flash once to confirm the system is in
valet mode. Shortly after the first flash, the parking lights will flash twice. A remote control is required to
take the system out of valet mode. IMPORTANT: If your system is set up for a secure valet option, you
will not be able to put the system into valet until the proper code has been entered to the secure valet
switch (see page 10 for details).
Remote Maintenance – Battery Replacement
The only regular maintenance this system requires is remote control battery replacement.
No programming is required when replacing the battery.
One-Way Remote: Model P1W900FMR and Model P1WSHR (US Style)
First, remove the small Phillips screw located on the back of the remote. Once the screw has been
removed, gently pull the remote apart being careful to not touch the circuit board. These remotes require
two CR2025 batteries. These specialty batteries can be purchased from your local CompuStar dealer or
an electronics store. IMPORTANT: Be sure to observe correct polarity when installing the battery.
One-Way Remote: Model P1WAMR and Model P1WSHR (Canada Style)
First, remove the small Phillips screw located on the back of the remote. Once the screw has been
removed, gently pull the remote apart being careful to not touch the circuit board. These remotes require
one 23A battery. These specialty batteries can be purchased from your local CompuStar dealer or an
electronics store. IMPORTANT: Be sure to observe correct polarity when installing the battery.
5