Filter
Top Products
Version Final - VF
CM4200 and CM1000S Starter Control Module Installation Manual
This manual is for authorized CompuStar dealers. Please thoroughly review this manual before beginning installation. If you
have any questions please contact your distributor or tech support 888-820-3690. (8:00 am to 5:00 pm Pacific Coast Time)
This is a simplified manual
. The Master Installation Manual is available on www.compustar.com.
1 Red
2 Green /
White
1: ( + ) 12v Constant 2: ( + ) Parking Light
Jumper
Cut = Auto | Uncut = Manual (Default)
3 Red/White 4 White 3: ( + ) 12v Constant 4: ( + ) Accessory
5 Blue 6 Yellow 5: ( + ) Output, *JM1
6: ( + ) Starter prewired to
Anti-Grind Relay
OFF / ON
CN1
7 Green and
Red
8 Black
7: ( + ) Ignition prewired to
Anti-Grind Relay
8: ( - ) Ground
Alternator /
Tach
DIP 1
15 (25) / 25
(45)
DIP 2
Dip Switches
1 Green/White ( - ) Parking Lt. Output 250 mA
Gas (Diesel)
2 Red/Black ( - ) Starter Output 250 mA
3 Violet ( - ) Output to Starter Kill 250 mA
3 2nd Starter
4 Black ( - ) Status Out (GWR) 250 mA
2 2nd Acc
5 Orange ( - ) Rearm Output 250 mA
*JM1
1 2nd Ign.
CN8
6 Orange/White ( - ) Disarm Output
CN2
7 White ( - ) Horn Output ( - ) Aux Wire (CM1000S)
Tach Switch
SW
CN12
1 Lt. Blue ( - ) E-Brake Input
TX 4 White
2 Gray/Black ( - ) Hood Input
RX 3 Blue
3
Lt.
Blue/White
( + ) Brake Input
( - ) 2 Black
4 Violet/Black ( - ) Trunk Input
( + ) 1 Red
CN7
RS232
5 Red/White ( - ) Door Input
6 Red ( + ) Door Input
4 ( - )
7 Brown/Black ( - ) Glow Plug Input
3 ( + )
8 Brown/White ( + ) Glow Plug Input
2 Tx
CN3
9 Yellow/Black Tach / Alternator Input
1 Rx
CN11
Antenna
1 None
2 Violet/White ( - ) Trunk Release Output 250 mA
3 Orange/Black ( - ) 2nd Unlock Output 250 mA
3 ( - )
4 Blue ( - ) Unlock Output 250 mA
2 Temp
5 Blue/Black ( - ) Lock Output 250 mA
1 ( + )
CN5
Temp.
Sensor
CN4
6 None
IMPORTANT:
CN7 RS232 Port – Firstech recommends not using this port for 1 or 2 way datalink connections. The protocol from the CM4200 and CM1000-S does not always match that of the current
bypass modules and may cause issues. Power and ground are still available for this port however we recommend hardwiring all bypass modules.
Additional Items to Install
Antenna Usually mounted on the front windshield. Stay at least 1 to 2 inches away from metal and try to mount below the tint stripe. IMPORTANT: use caution when
running the antenna cable and keep it free from snags and where it can be pinched when reassembling the vehicle.
Hood Pin
start is engaged.
This is included in the wiring kit and Firstech recommends installing this in any vehicle. This is to prevent any injury or damage if the hood is open and the remote
1