Filter
Top Products
© 2001 Firstech, Inc. Page 14
ADDITIONAL FEATURES
ADDITIONAL FEATURESADDITIONAL FEATURES
ADDITIONAL FEATURES
The CompuStar 2000AS remote-pager has additional features and expansion
possibilities.
Second Car Mode
Second Car ModeSecond Car Mode
Second Car Mode
CompuStar 2000AS remote-pager can be programmed to operate a second vehicle.
Press Buttons (III+IV) simultaneously for a ½ second to enter second car mode. A
red–bordered indicator box labeled 2
nd
located on the top left-hand corner of your
CompuGlo LCD will darken illustrating that your are in this mode.
If you are in second car mode, you can program your remote-pager to the second
vehicle by following the steps illustrated in the section below entitled “Adding an
Additional Remote-Pager.” In order to exit second car mode, press Buttons (III+IV)
simultaneously again. Please contact your local authorized CompuStar dealer for
more information.
Adding an Additional Remote
Adding an Additional RemoteAdding an Additional Remote
Adding an Additional Remote-
--
-Pager
PagerPager
Pager
Your remote-pager has been programmed at the factory. However, if you replace or
add an additional remote-pager, please perform the following:
Steps 1: Put the system in Valet mode with the key by turning the ignition on and off
five times with the mechanical car key within 10 seconds. The parking light will flash
once.
Step 2: Within 6 seconds, press Button I for a ½ second.
Step 3: The parking light will flash twice to confirm Step 2.
Step 4: Program the second transmitter or third transmitter by pressing any button.
The system will program up to 3 transmitters. The parking light will flash once to
confirm Step 3.