Filter
Top Products
7
Quick Reference Button Operation Guide.
Operation Function Lock Unlock Trunk KEY
OPT F Operation Method
Lock X Press and Release
Unlock X Press and Release
Headlight X Press and Hold for 3 seconds
Trunk X Press and Hold for 2 seconds
Car Finder X X Press and Release
Panic X X Press and Hold for 2 seconds
Remote Start X Press two times in 2 seconds
Temp Start X X Press and Release
Daily Start X X Press and Release
AUX1 X Press and Release
AUX2 X Press and Hold for 2 seconds
AUX3 X X Press and Hold for 2 seconds
AUX4 X X Press and Hold for 2 seconds
Check Status X X X Press both together for 1 second
Check Temp X X Press both together for 1 second
Battery Saver X X Press and Release, When System is Disarmed
Vibrate X X Press and Release
2/4 hour start X Press 4 times after remote start shut down
Shock Bypass X Press and release 2, 3, or 4 times
Parking Meter Timer X X Press and release 1, 2, 3, 4, 5 or 6 times
Alarm clock X X Press and Release
Fahrenheit / Celsius X X X Press and Release
Replacing Remote Control Batteries
2-way LCD Remote Control:
The AAA alkaline battery inside the 2-way LCD remote control should last approximately 1 year under normal use.
When the battery becomes weak you will notice the remote control range (the distance from the vehicle the remote
control will work) deteriorate and the BATTERY icon on the LCD remote control will display. To replace the remote
control battery:
1. Lift and slide the battery cover off of the remote control.
2. Remove the old AAA battery, observing the +/- symbols on the battery, and replace with a new
AAA battery.
3. Gently slide the battery cover onto the back of the remote control until it locks into place.
4. Test operation of the remote control.
1-Way 5 Button Remote Control:
The two 3 volt lithium batteries (model CR2032 or Code Alarm part # 6BA) inside each remote control should
last approximately 1 year under normal use. When the batteries become weak you will notice the remote control
range (the distance from the vehicle the remote control will work) deteriorate and the small LED on the remote
control will dim. To replace the remote control batteries:
1. Using a small (#1) philips screwdriver, remove the 2 screws on the back of the remote control.
2. Gently unsnap the halves of the remote control apart.
3. Slide the lithium batteries out of the circuit board, observing the +/- symbols on the batteries
and replace with new lithium 3 volt batteries (model CR2032 or Code Alarm part # 6BA)
4. Gently snap the halves of the remote control back together and reinstall the philips screws
on the back of the remote control.
5. Test operation of the remote control.