Filter
Top Products
3
Using Your Remote Control
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the LOCK button on the remote control. The system
will sound 2 times and the parking lights will flash 2 times, indicating the system is armed, has locked the doors (if
equipped and connected) and activated the starter disable feature. The status indicator (blue warning light on the
dash) will blink steadily, once per second. To arm the system silently, press and hold the LOCK button for 1 second.
The parking lights will flash 2 times, indicating the system is armed, has locked the doors (if equipped and
connected) and activated the starter disable feature. The status indicator (blue warning light on the dash) will blink
steadily, once per second.
Pre-arm Mode
If the system sounds 1 time and the parking lights flash only 1 time, this indicates that the vehicle’s interior light is
on or an entrance is left open. Check to see that all doors hood and trunk are closed properly. Once all entrances
are secured (and the interior light is off), this system will sound/flash again. The system is now fully armed. (If the
entrance is not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system press the UNLOCK button. The system will sound and the parking lights will flash once, and
the doors will unlock (if equipped and connected). To disarm the system silently, press and hold the UNLOCK
button for 1 second. The parking lights will flash, indicating the system is disarmed and has unlocked the doors (if
equipped and connected).
Disabling/Enabling Confirmation Chirps
1. Turn the ignition key ON then OFF.
2. Within 10 seconds push and release the valet/override button 3 times.
3. The system will sound 2 times to disable confirmation chirps or 1 time to enable confirmation chirps.
Attempted Intrusion Identification
This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an intrusion
attempt occurred, the system will sound 4 times and the parking lights will flash 3 times when disarming the system.
Enter the vehicle an observe the dash mounted status LED to Identify which zone was triggered.
1. Shock Sensor - 1 flash, pause 1 flash, etc.
2. Hood or Trunk Pin switch - 2 flashes, pause 2 flashes, etc.
3. Door Entry - 3 flashes, pause 3 flashes, etc.
The intrusion warning indicators are stored in the system’s memory and will be erased when the ignition key is
turned on.
Two Stage Door Unlock (Optional)
If this feature is enabled on your system, pressing the UNLOCK button one time on the remote control will unlock
only the driver’s door. Press UNLOCK again to unlock the remaining doors.
Activating the Trunk Release Feature (Optional)
If this feature is enabled on your system, pressing and holding the TRUNK button on the remote control for 2
seconds will open the vehicle’s trunk or hatch.
*Throughout this manual, ‘press’ refers to pressing for less than 1 second, ‘press and hold’ refers to pressing for
more than 2 seconds.