Filter
Top Products
Additional Dot Matrix Remote Control Functions
Check Vehicle Status
Press the LOCK icon button, TRUNK icon button and OPTION button simultaneously for 1 second. The
Dot Matrix remote control will display the system’s current status.
Check Temperature
Press the TRUNK icon button and OPTION button simultaneously for 1 second. The LCD remote control
will display the vehicle’s interior temperature.
Dot Matrix Remote Control Display Illumination
Press and release the “F” button on the LCD remote control one time. The display will illuminate for 10
seconds.
Dot Matrix Remote Control Vibrate or Tones
Press an release the “F” button and the UNLOCK icon button on the LCD remote control simultaneously
one time to toggle between beep tones and vibrate mode. The LCD remote control will either beep or
vibrate to indicate which mode is selected.
Page Call Out
From within the vehicle, press and hold the emergency override button for 4 seconds, the LCD remote
control will emit a beep tone to indicate that someone is calling you to the vehicle.
Countdown Timer
The Dot Matrix remote control is equipped with a countdown timer for situations where an alert tone may
be needed to remind you of something important. The countdown timer allows you to set the timer up to
19 hours and 59 minutes. Refer to page 9 for programming.
Parking Meter Timer
The Dot Matrix remote control is equipped with a parking meter timer that allows you to set a countdown
timer for 10, 20, 30, 60, 90 or 120 minutes. The LCD remote control will emit a beep tone when the timer
expires. Press ”F” and OPTION simultaneusly to select desired time.
Alarm Clock
The Dot Matrix remote control is equipped with a built in alarm clock that can be set to beep at a certain
time each day. The alarm clock must be set, and the feature turned on. Refer to page 9 for programming.
Bypassing The Shock Sensor
There are 3 additional modes of operation in which your system will react to the shock sensor, FULL
TRIGGER ONLY, ALL OFF, or CITY MODE.
Press LOCK once to arm the system.
Pressing LOCK again within 2 seconds will set the system to FULL TRIGGER ONLY in which the system
will ignore the light touch setting.
Pressing LOCK again within 2 seconds will set the system to ALL OFF. In this mode the system will not
react to the shock sensor and the 2-way LCD remote will display the shock sensor icon.
Pressing LOCK again within 2 seconds will set the system to CITY MODE. In this mode light touch is
extended to a full 10 seconds and full trigger is shortend to 15 seconds, no icon is displayed.
NOTE: The system will only change the shock sensor setting for one arm cycle and will be defaulted back to
normal operation the next time the system is armed.
6