Filter
Top Products
128-6530
4 of 10
Page 4
ELIMINATING THE NORMAL ARM/DISARM CHIRPS
You can selectively eliminate the normal arm & disarm chirps by holding the
transmitter button slightly longer when locking or unlocking. This will prevent
the horn chirps for one arm or disarm cycle. If you find this inconvenient and
wish to eliminate these chirps permanently, please check with your installation
center.
REMOTE PANIC OPERATION:
The PANIC button on your keychain transmitter functions as a panic switch for
use in emergency situations. To use remote panic;
1. Press and hold the PANIC button on the keychain transmitter for 3 or more
seconds. The horn will immediately start honking.
2. To stop the honking, press and hold the PANIC button on the transmitter
again for 3 seconds. If the button is not pressed, the horn will
automatically stop honking after 30 seconds.
NOTE: While in the panic mode, pressing and releasing the lock, or the
unlock buttons will, if the option is installed, lock and unlock the doors
respectively. While in the panic mode, anytime the unlock button is pressed,
the panic feature will continue for the allotted 30 seconds, however, the vehicle
will be unlocked allowing the vehicle to start.
ADDITIONAL REMOTE FUNCTION CHANNEL 2
The system has an optional feature, (Channel 2), that can be connected to the
Trunk Release. To operate channel 2, press and hold the TRUNK button of
your keychain transmitter for four seconds.