Code Alarm CA100 Automobile Alarm User Manual


 
128-6530
6 of 10
Page 6
the panic feature will continue for the allotted 30 seconds, however, the
security system will be disarmed allowing the vehicle to start.
ADDITIONAL REMOTE FUNCTION CHANNEL 3
The system has an optional feature, (Channel 3), that can be connected to the
Trunk Release. To operate channel 3, press and hold the UNLOCK button of
your keychain transmitter for four seconds.
ANTI HI-JACK MODE OPERATION
1. a) With the ignition switch on, and the doors closed, press and hold both
buttons of your keychain transmitter for 1 second to initiate the anti hi-jack
mode or open the door any time the ignition is on.
b) If while the ignition is on, and a door is opened and then all doors are
closed, the system will enter the anti hi-jack mode. The parking lights will turn
on for 1.5 seconds to indicate the mode was initiated.
2. 60 seconds after initiation, the siren will begin to sound and the parking
lights will begin to flash.
3. 90 seconds after initiation, the starter inhibit circuit, (if installed) will be
activated, the siren will sound and the parking lights will flash until the
vehicle's battery is dead, or until the system is reset.
Note: If you are the unfortunate victim of a vehicle hi-jack, for your personal
safety, it is best to leave the vehicle as quickly as possible. Never attempt to
oppose the teief in any way. If the thief prevents you from leaving the vehicle,
disarm the anti hi-jack mode to prevent the system from soundin while you are
in the presence of your captor. Once you exit the vehicle, opening and then
closing the door will initiate the anti hi-jack mode,and the system will go
through the cycle mentioned above. Once the engine is turned off, it cannot be
restarted if the optional starter inhibit circuit is installed. The system will
continue to make noise from the siren or horn and the parking lights will
continue to flash until the vehicle's battery is dead, or until the system is reset.
DISARMING ANTI HI-JACK MODE
Anytime after the anti hi-jack mode has been triggered, the circuit can be
disarmed simply by pressing the hidden push button switch. Depressing this