Filter
Top Products
EasySet Programming
Nothing Comes Close to a Cobra
®
7
EasySet Programming
6
English
EasySet Programming
•
All user mode settings on your detector can be changed by using
Program mode. When changing the settings, please keep in mind:
■
Buttons can have multiple functions.
■
All settings will be stored in memory when the power is
turned off and recalled when the power is turned back on.
The procedure for using Program mode is shown on page 7.
NOTE
You cannot enter Program mode during an alert. The unit will not detect
signals while in Program mode. During programming, if no buttons are
pushed for ten seconds, the unit will automatically exit Program mode
and save the last settings.
Programming User Modes
The tables on pages 8 through 9 show you how to program all user modes
and the settings you can choose from.
NOTE
On the following pages, you will find more detailed
explanations of each setting.
See page 15 for instructions on setting the IntelliMute activation point.
See page 17 for instructions on calibrating the compass.
See page 22 for instructions on using SmartPower.
Intro Operation Customer
Assistance
Warranty
Notice
S
econdary Icons
Your Detector
Intro Operation Customer
Assistance
Warranty
Notice
S
econdary Icons
Your Detector
Program/Mute Button
Press and hold/Press and release
Select/Dim Button
Press and release
Set/City Button
Press and release
To Use Program Mode
Press and hold the
Program/Mute button
for two seconds.
Tone
Visual Display Voice
Three beeps Program will appear.
Then brief programming
instructions will scroll
through the display three
times.
Start Program
While the programming
instructions are
scrolling, press and
release the Select/Dim
button to cycle through
the user modes.
One beep
with each
button press
As each mode is displayed,
the current setting for that
mode will be shown.
None
With the user mode you
wish to change displayed,
press and release the
Set/City button to
change the setting.
To move to the next
selection, press the
Select/Dim button again.
One
or two
beeps,
depending
on your
selection
The setting you
select will be shown.
Current
setting
When you have finished
programming any or
all of the user modes,
press and release the
Program/Mute button
to exit Program mode.
Or simply wait ten
seconds without
pushing any buttons.
One beep When you exit Program
mode, the new setting
will automatically be saved
and EXIT PROGRAM and
Settings Saved! will appear.
Exit Program
EXIT
PROGRAM
PROGRAM
Settings
Saved!
Intro Operation Customer
Assistance
Warranty
Notice
i
n Icons
condary Icons
I
ntro Operation Customer
A
ssistance
W
arranty
Notice
i
n Icons
condary Icons