Filter
Top Products
Getting Started
Getting Started
•
Intro Operation Customer
A
ssistance
Warranty
N
otice
Secondary Icons
Your Detector
Nothing Comes Close to a Cobra
®
5
Installation
Intro Operation Customer
A
ssistance
Warranty
N
otice
Secondary Icons
Your Detector
4
English
Dashboard Mounting
System Ready
Power On
Testing
On-Off/
Volume Control
Rotate clockwise
(away from you)
NOTE
In some vehicles, power is supplied to the cigarette
lighter even while the ignition is off. If this is the case
with your vehicle and you have turned the SmartPower
off, you should turn off or unplug your detector when
parking for lengthy periods. Cobra recommends leaving
SmartPower at the factory setting, which is on.
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Start-Up Complete
NW h
1. Place the detector on the dashboard to find a location
where the unit has a clear, level view of the road.
The angle can NOT be adjusted after mounting.
2. Remove the paper backing
from one side of the hook-
and-loop fastener.
3. Attach the pad to the
dashboard at your chosen
location and remove the
other paper backing.
4. Attach the detector to the
hook-and-loop fastener.
You can remove and
reattach the unit as
often as you like.
5. Plug the power cord
into the detector.
6. Plug the cigarette lighter
adapter on the power
cord into your vehicle’s
cigarette lighter.
To Turn On the Unit and Adjust the Audio Volume
Rotate the On-Off/
Volume control
clockwise (away
from you).
Tone
Visual Display
Three beeps Testing
System Ready
The display will then cycle
through the user mode settings
(city or highway, Intellimute
and SmartPower status).
Start-up is complete when the display continuously
shows the current compass direction (N, NE, E, SE, S,
SW, W or NW) plus single letters indicating current user
mode settings (c = City mode, City X Beep Off mode and
City X+K mode, h = Highway mode, i = IntelliMute on).