Filter
Top Products
NOTE: If you do not press the SET/CITY
button within 2 minutes, compass
calibration will automatically terminate
1 beep Error
for 2 seconds
3
OPERATION•SETTINGS
3
OPERATION•SETTINGS
13
12
Compass
Your ESD-9560 includes an internal 8-point
compass that will continuously display your
current direction of travel: N, NE, E, SE, S,
SW, W, or NW.
Calibrating the Compass
Important: Before using it for the first
time, you must calibrate the compass to
provide accurate indications of direction.
(See page 7 for instructions on using the
Program mode to select Set Compass.)
Calibration allows the compass electronics to
measure and store information about the
magnetic fields generated by your vehicle.
The compass will remain accurately
calibrated as long as your ESD-9560 is
mounted in the same place in your vehicle.
If you change the location where the unit is
mounted or move it to another vehicle, you
must recalibrate the compass.
The compass temporarily may not provide
accurate readings if you are inside a
building or enclosure, or are close to a
large metal tractor/trailer, truck, or train.
Once you are away from such a location,
the compass will work correctly again.
NW h
Error
1.
Procedure
In Program mode, go to Set compass.
Press and hold the SET/CITY button to
begin setting the compass.
Tone
2 beeps
Visual Display
Drive in 2 circles…
Press SET when done...
2.
Procedure
Within 2 minutes,
drive your vehicle
in a circle twice,
then press
the SET/CITY
button again.
Tone
3 beeps
Visual Display
Compass Set!
for 2 seconds
followed by
direction of travel
(N, NE, E,
SE, S, SW,
W, or NW)
3.
Procedure
Press and release either the
SELECT/DIM button to proceed
to the next user mode or the
PROG/MUTE button
to exit Program mode.
Tone
none
Visual Display
none
To calibrate the compass: