Filter
Top Products
English
10
Settings
Your Detector
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Nothing Comes Close to a Cobra
®
11
Detection
Your Detector
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Radar Alert Settings
The detector allows you to choose whether it will show alerts on the X, K and Ka
Bands. The factory settings are: X, K, and Ka On.
Signals Detected
The tables on the following pages show you the types of Signals your detector will
detect, as well as the visual alerts it provides for each of them.
Audio Alerts
A distinctly different Alert tone and voice message is used for each type of signal
detected (including separate tones for each laser signal). For X, K and Ka band
radar signals, the tones will repeat faster as you approach the signal source. The
repeat rate of the tones gives you useful information about the signal detected.
(See responding to alerts on page 14.)
Visual Display
An indication of the type of signal
detected and, for radar signals, the signal
strength will appear in the UltraBright
Data Display. Radar signal strength will
be indicated by steady, ashing, or a
combination of steady and ashing
LEDs as shown in the signal strength
chart below.
To Turn X Band On and Off
While no signal
is being detected,
press and hold
both the Dim and
Mute buttons for
four seconds.
Tone Mode Voice Mode Visual Display
X On = Two beeps X On X/K LED Flashes Twice
X Off = One beep X Off X/K LED Flashes Once
To Turn K Band On and Off
While no signal
is being detected,
press and hold both
the Mute and City
buttons for
four seconds.
Tone Mode Voice Mode Visual Display
K On = Two beeps K On X/K LED Flashes Twice
K Off = One beep K Off X/K LED Flashes Once
To Turn Ka Band On and Off
While no signal
is being detected,
press and hold
the Dim and City
buttons for
four seconds.
Tone Mode Voice Mode Visual Display
Ka On = Two beeps Ka On Ka LED Flashes Twice
Ka Off = One beep Ka Off Ka LED Flashes Once
Signal Strength Chart
Signal Strength = 1
(Weakest Signal)
Signal Strength = 5 (Strongest Signal)
X/KKaLV/S
l
lll
lllll
C
X/KKaLV/S
l
lll
lllll
C
X/KKaLV/S
l
lll
lllll
C
X/KKaLV/S
l
lll
lllll
C
X/K Ka L V/S
l
lll
lllll
C
NOTE: In This Manual
When steady,
the display will
be shown:
When ashing,
the display will
be shown:
X/KKaLV/S
l
zzz
zzzzz
X/KKaLV/S
l
zzz
zzzzz
Signal Strength = 4
ESD9290_MANL.indd 10-11 12/15/09 3:01 PM