Filter
Top Products
15
3
OPERATION•SETTINGS
14
3
OPERATION•SETTINGS
NOTE: If you do not press the SET/CITY
button within 2 minutes, compass
calibration will automatically terminate
1 beep Compass not set...
Please try again...
for 2 seconds
Compass
NW h
Compass
not
1.
Procedure
In Program mode, go to Set Compass.
Press and hold the SET/CITY button to
begin setting the compass.
Tone
2 beeps
Visual Display
Set Compass
Drive in 2 circles…
Press SET when done...
2.
Procedure
Within 2 minutes,
drive your vehicle
in a circle twice,
then press
the SET/CITY
button again.
Tone
3 beeps
Visual Display
Compass Set!
for 2 seconds
followed by
direction of travel
(N, NE, E,
SE, S, SW,
W, or NW)
3.
Procedure
Press and release either the
SELECT/DIM button to proceed
to the next user mode or the
PROG/MUTE button
to exit Program mode.
Tone
none
Visual Display
none
To calibrate the compass:
Set!
Compass
Your detector includes an internal 8-point
compass that will continuously display your
current direction of travel: N, NE, E, SE, S,
SW, W, or NW.
Calibrating the Compass
Important: Before using it for the first
time, you must calibrate the compass to
provide accurate indications of direction.
(See page 15 for instructions on using the
Program mode to select Set Compass.)
Calibration allows the compass electronics to
measure and store information about the
magnetic fields generated by your vehicle.
The compass will remain accurately
calibrated as long as your detector is
mounted in the same place in your vehicle.
If you change the location where the unit is
mounted or move it to another vehicle, you
must recalibrate the compass.
The compass temporarily may not provide
accurate readings if you are inside a
building or enclosure, or are close to a
large metal tractor/trailer, truck, or train.
Once you are away from such a location,
the compass will work correctly again.
Drive
in
2
c
Press
SET
wh
Please
try
a