Clifford XL2000 Automobile Alarm User Manual


 
AntiScan
Car thieves use electronic scanners that rapidly transmit one remote control code
after another to defeat ordinary alarms. AntiScan prevents scanners from
disarming your system.
Automatic Fault-Proof Starter Interrupt
The system automatically prevents engine starting while the system is armed but
allows you to start it even in the unlikely event of a full system failure (other
manufacturer’s alarms may leave you stranded).
Multi-Level Chirp Control
Whenever you wish, you may lower the volume or completely silence the system’s
arm/disarm chirps. The short-term and one-time chirp muting capabilities are
especially valuable when parking late at night in a quiet residential area. You have
several choices:
Chirp Volume Control: Lets you lower the volume of the chirps or restore
them to full volume. See User-Selectable Features on pages 9-10.
Extended Chirp Silencing: Lets you completely silence the chirps until you
wish to restore them. See User-Selectable Features on pages 9-10.
Short-Term Chirp Muting: Lets you silence the chirps for a single arm-and-
disarm cycle. To enable short-term chirp muting, simply turn the vehicle’s igni-
tion switch rapidly ON then OFF. The next time you arm and later disarm the
system, there will be no chirps. After which, the chirps are restored.
One-Time Remote Chirp Muting: The most simple of all. To remotely arm or
disarm the alarm silently, press button III (switch up) on the remote control.
Remote Headlight Activation OR Window/Sunroof Closure
The system’s built-in timer can control one of two great features when the system
is in its armed state (these features require optional wiring):
Remote Controlled Headlight Activation
OR
Remote Controlled Window/Sunroof Closure (available only on certain vehicles)
Please see page 4:
“To Activate an Option when the Alarm is Armed.”
If connected
to the headlights, you may set the timer duration to any interval between 1 second and
2.5 minutes. See the User-Selectable Features section on pages 9-10.
WARNING: If your built-in timer controls window/sunroof closure in your car
DO NOT change the timer setting! This requires installer-only programming.
Changing the value will adversely effect operation and may cause damage.
8