Filter
Top Products
User-selectable features
Your SuperNova vehicle security system allows you to set many of its features to your
own personal preferences. We have made the programming procedures very simple: to
make a change, you just press the PlainView switch a few times.
The system comes from the factory with all of its features pre-programmed as noted in the
table below and on page 12. To change any of the settings, use the procedure noted. To
restore the feature to its factory setting, just repeat the procedure:
1. Select the feature you wish to program from the table below and on the following
page. Note the number of momentary (spring-loaded) presses.
2. Turn your vehicle’s ignition switch to its “ON” position.
3. Enter your valet code on the PlainView switch.
4. When the LED turns on, immediately tap and release the momentary side of the
switch the number of times indicated in the third column of the programming
table for the feature you selected (after the first three taps, you will hear a single
chirp confirmation each time you tap the momentary side).
a. If noted, perform the “secondary action.”
5. Return the switch to its center position and wait 3 seconds. You will hear 1 chirp
and the LED will turn off. Turn the ignition off and you will hear 3 chirps to
indicate that you have exited programming mode.
6. Repeat steps 1-5 for any other features you wish to program.
Programming table for user-selectable features
Feature
Factory
setting
# of
momentary
presses
Secondary
action
Program
completion
confirmation
Result
AutoArming
ON
4
—
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
AutoArm
& Lock
OFF
5
—
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
Arm/Disarm
Chirp
Confirmation
ON
6
—
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
Valet Code
See How to set your own secret valet code on page 7.
AutoLock/
AutoUnLock
ON
9
—
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
Siren
Duration
30 sec.
10
—
1 chirp 3
seconds after
last step
Change duration from 30 to
60 seconds or vice-versa
continued . . .
11