Filter
Top Products
The Optional Remote Keyless Entry System PLUS
If your Remote Keyless Entry System has been equipped with the Plus option package,
your system has even greater functionality (your local Authorized Clifford Dealer can
add the Plus option to your Remote Keyless Entry System anytime). The package
includes our patent-pending PlainView™ Coded Valet Switch that allows you to easily
expand and customize the features of your Remote Keyless Entry System system.
Using the PlainView Coded Valet Switch
Before changing any feature settings or placing the system in UltraSecure™ Valet Mode
(see page 8), you must first enter your secret valet code to tell the system you are
authorized to make these changes. Your valet code will be any one-to-three digit number
of your choosing.
NOTE: If you temporarily lose the use of your remote controls, you can turn off
the starter interrupt feature of the system by enabling valet mode.
Definitions:
Digit: A digit is defined as any number from 1 to 9, inclusive.
Valet code: A valet code may be 1 to 3 digits: A one-digit code = X = any
number between 1-9.
A two-digit code = XY = any number between 11-99 (excluding those
numbers with zeros).
A three-digit code = XYZ = any number between 111-999 (excluding those
numbers with zeros).
Remember, no code can have a zero.
PlainView Switch: A rocker-switch mounted on the dashboard or console with
three positions: 1.) Latched 2.) Center 3.) Spring-loaded momentary. When
you press the latched side, the switch remains in its latched position. When
you press the momentary side, the switch bounces back to its center position.
Entering a digit: To enter a digit, you tap (press and release) on the momentary
side of the PlainView switch the number of times corresponding to the
numeral of the digit to be entered, followed by pressing to the latched side,
then returning the switch to its center position.
Entering a code: If your code has only one digit, enter the code as described in
“Entering a digit,” then return the switch to its center position. If your code
has more than one digit, just repeat this procedure for each digit of your code,
then return the switch to its center position.
Currently, your factory-set valet code is the single digit “2.”
6