Filter
Top Products
7
© 2008 Directed Electronics - all rights reserved
Valet
®
mode
You can prevent your system from arming, by using Valet
®
Mode. This
is very useful when washing the vehicle or having it serviced. In Valet
®
Mode, the system will not arm, even with the transmitter, but all con-
venience functions (door locks, boot release, etc.) will work normally.
To enter or exit Valet® Mode with the Valet® switch:
1. Turn the ignition to ON position, and then turn it to the OFF
position.
2. Press and release the Valet
®
button within 10 seconds.
3. The status LED will light steady if you have entered Valet
®
Mode.
4. To exit Valet
®
Mode, repeat the steps above. The LED will turn
off when exiting Valet
®
Mode.
Panic mode
(If programmed On, above steps 3-4 )
If you are threatened in or near your vehicle, you can attract attention
by triggering the system with your transmitter! If your factory keyless
transmitter does not have a panic button, this system can be pro-
grammed to enable a panic feature.
G330X_1-3_2008_02B.qxd 2/14/2008 4:28 PM Page 7