Filter
Top Products
10
© 2004 directed electronics, inc.
Page notification
The remote control can be programmed to notify the user of a
page (audibly beeping if the vehicle’s status changes, e.g. door
unlocked, engine started, vehicle violation, etc.). Press to
select page On/Off. One beep is page On, Two beeps is page Off.
When programmed off the remote will not give any notification
that a page was received from the vehicle.
To exit programming mode
The remote control will exit programming mode after 2-seconds
of inactivity and will emit 2 long beeps.
uussiinngg yyoouurr ssyysstteemm
The buttons used in the instructions in this manual correspond
to the standard configuration. Remember, this is not the only
way your 2-way remote may be set up. It can be custom config-
ured to meet your needs.