Filter
Top Products
Remote Transmitter Layout
Each MS3001 / MS3200 system comes with 2 multifunction Remote Transmitters used to control
nearly all of the system’s features.
Each time a transmitter button is pressed, the LED will flash to indicate that a transmission is
taking place.
Button 1 Arms and Disarms the system. This Button also locks and unlocks the doors when the
system is in Valet Mode.
Button 2 controls the system’s Auxiliary Function 1, which is normally used for activating a car’s
electric trunk release.
When Button 1 and 2 are pressed together, the system will Arm or Disarm
silently
(without chirp
confirmation).
As an option, your installer can set system to
always
arm without chirp confirmation. If this is done, then
pressing Buttons 1 and 2 together will Arm or Disarm the system
with
chirp confirmation.
The Mode Button will change the function of Buttons 1 and 2 when it is pressed, allowing
Buttons 1 and 2 to control the system’s Auxiliary Function Outputs.
Note also that the LED on the transmitter turns green when the Mode Button is pressed to
indicate the current function of Buttons 1 and 2. The LED will stay on for 5 seconds, then turn
off, returning Buttons 1 and 2 to their default settings.
It is also possible to set individual Remote Transmitters to arm and disarm the system using any
of the Transmitters function Buttons, which is extremely useful when a Transmitter is used to
control multiple systems. See
Adding a Remote Transmitter into the System.
Remote Transmitters
Button 1
Button 2
Mode Button
LED
Page 2 - MS3001 / MS3200 Owner’s Manual
MS3001_owner's.qxd 9/10/99 5:27 PM Page 2