Filter
Top Products
MS3001 / MS3200 Owner’s Manual - Page 11
Dome Light Control
As an option for increased safety and convenience, the system can be set, during the installation,
to automatically turn on the dome light when you Disarm the system and when you turn off the
ignition.
Illuminated Entry. The dome light will turn on for 20 seconds when the system is disarmed (or
unlocked in Valet Mode) using the Remote Transmitter.
Illuminated Exit. If the ignition key has been on for at least 10 seconds, the dome light will turn
on for 20 seconds when you turn off the ignition.
Auxiliary Function Outputs
The system is equipped with two Auxiliary Function outputs that can be used to control a variety
of additional features including, electric trunk release, remote car starter, power windows, power
sunroof, stereo system valet, garage door receiver, etc.
Auxiliary Function 1 - momentary
Normally, this function is used to activate a power trunk release.
To operate Aux. 1, press Button 2.
This function will operate regardless of whether the system is armed or disarmed and will
stay active for as long as Button 2 is held.
Sensor Defeat with Auxiliary 1 (Dedicated Remote Start Mode). When your system is used with an optional Remote
Car Starter (Ungo model SAA4295), Auxiliary Function 1 can be selected to remotely start your car’s engine. With the
MS3001 / MS3200’s Dedicated Remote Start Mode enabled, when Auxiliary Function 1 is used to activate the Remote Car
Starter while the system is armed, the Shock Sensor and optional sensor inputs will be ignored. This will allow the alarm
to continue protecting the door and hood/trunk inputs, but prevent it from triggering due to the motion of the engine starting
and running.
This feature must be enabled by your installer at the time of installation.
Sensor Defeat with Auxiliary 1 (Remote Shock Sensor Bypass). If the Auxiliary Function 1 is not used to activate an
auxiliary feature, it may be used as a remote shock sensor bypass instead. In case of extreme weather conditions such
as high winds, the Shock Sensor can be temporarily bypassed from the Remote Transmitter while the system is armed to
prevent the system from false alarming.
To use this feature, Sensor Defeat with Auxiliary 1 must be enabled by your
installer at the time of installation
.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 11