Filter
Top Products
Adding a New Transmitter into the System
The Ungo MS850 has the ability to recognize up to 21 individual remote transmitters. If the
vehicle is used by multiple drivers, each can have their own Remote Transmitter.
To add a Remote Transmitter:
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
3. Within 5 seconds:
Continue holding the Override switch
and Press Transmitter Button 1* for remote
arming
with
chirp confirmation.
--- or ---
Release the Override switch
and Press Transmitter Button 1* for remote arming
without
chirp confirmation.
• The status LED will flash once quickly to confirm that the new Remote Transmitter
has been added.
4. Turn off the ignition.
* The Button that is pressed will be the Arm/Disarm Button on that Remote Transmitter. You may program
either
of the
Transmitter’s function buttons to arm and disarm the system at this point.
Deleting Transmitters (Adding a Remote Transmitter
and
Erasing All
Other Remote Transmitters From the System)
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
Continue to hold the Override switch.
• After 5 seconds, the status LED will flash 4 times, then turn on red again.
3. Within 5 seconds:
Continue holding the Override switch
and Press Transmitter Button 1* for remote
arming
with
chirp confirmation.
--- or ---
Release the Override switch
and Press Transmitter Button 1* for remote arming
without
chirp confirmation.
• The status LED will flash once quickly to confirm that the new Remote Transmitter
has been added.
4. Turn off the ignition.
* The Button that is pressed will be the Arm/Disarm Button on that Remote Transmitter. You may program
either
of the
Transmitter’s function buttons to arm and disarm the system at this point.
MS850 Owner’s Manual - Page 5
owners_850.qxd 9/10/99 6:43 PM Page 5