Filter
Top Products
Page 5SKU 96157
For technical questions, please call 1-800-444-3353.
DC Adapter (31)
AC Adapter (30)
To charge from an AC power source3. . After the initial charge, use only the AC
Adapter (30) provided with the unit. Plug first into any standard 120V socket, and
then into Power Pack. Allow up to 34 hours for the unit to fully charge. The pack
must not be continually charged for over 34 hours at a time.
When the Power Pack is fully charged, unplug from the 120V socket and unit. 4. Do
not exceed the maximum AC charge time of 34 hours.
To charge from a DC power source5. , plug the DC Adapter (31) into any 12V outlet
and then into the AC/DC charging jack on the front of the unit.
After the initial charge, fully charging the Power Pack by a DC connection will take 6.
about 12 hours. Do not exceed the maximum DC charge time of 12 hours.
Note: The Charging Indicator light will illuminate when the Power Pack is charging with
both AC or DC input. The Charging Indicator light will not turn off when the
charging is complete. The Voltmeter (10) must be checked periodically when
charging and the Power Pack must be unplugged when the unit is fully charged.
DO NOT OVERCHARGE.
Work Light
To turn on the L.E.D. Work Light (13), push the Work Light Switch (25) to the “ON”
position. Turn Work Light Switch to “OFF” position when done.
Jump-starting
Note: Read the vehicle owner’s manual prior to using the Power Pack to jump-start the
vehicle.
Turn off the ignition switch of the vehicle and all accessories (lights, radio etc.) of 1.
the vehicle off.
Turn 2. all switches on the Power Pack off.
Caution: Do not touch Positive and Negative Battery Clamps together.
Connect the red Positive Battery Clamp (27) to the vehicle’s positive battery ter-3.
minal.
REV 08a