Filter
Top Products
Waste Water Tank Dumping:
To dump the exterior black waste water tank:
1. Turn the battery disconnect switch to the “ON”position,if not already on,(located on the monitor panel).
2. Remove sewage discharge hose from storage, (see Picture G-P17).
3. Insert the discharge outlet into the waste receptacle.
4. Open the valve on the sewage hose,(see Picture G-P18).
5. Open the black water tank valve,(see Picture G-P14).
6. Open the driver’s door,press and hold the macerator pump switch until the tank is empty,(see Picture G-
P16).
To dump the grey waste water tank:
1. Open grey water tank valve.
2. Repeat step 6.
3. Close all valves.
4. Return sewage hose to its storage compartment.
5. Turn battery disconnect to the “OFF”position.
NOTICE: It is recommended to always dump the black water tank first,then the grey water tank.
NOTE: If macerator should get clogged you will have to push and turn the manual macerator crank "T" handle
to dislodge any debris that might be blocking the macerator, (see picture G-P15).
WATER SYSTEMS
DDoocc NNoo::
21906532-210C05
RReevv::
02
CCooppyyrriigghhtt ©© HHaannmmaarr MMoottoorr CCoorrppoorraattiioonn 22000055 GG--77
Picture G-P15: Macerator
pump located under center
of vehicle.
Picture G-P16: Macerator
pump switch located on
driver’s door post.
Picture G-P17: Sewage
discharge hose storage
located in driver’s side
storage drawer.
Picture G-P18: Sewage
hose discharge valve.
Macerator manual
crank handle