Filter
Top Products
WATER SYSTEMS
DDoocc NNoo::
21906532-210C05
RReevv::
02
CCooppyyrriigghhtt ©© HHaannmmaarr MMoottoorr CCoorrppoorraattiioonn 22000055 GG--66
To disconnect the city water connection:
1. Turn off the external water source.
2. Open the sink faucet to relieve the pressure in the system,(failure to do so may result in an unexpected
shower).
3. Ensure that the city water tank fill valve is closed,(see Picture G-P12).
4. Remove the hose from the city water connection, replace the cap on fill connection.
WASTE WATER STORAGE AND DUMPING SYSTEM:
Your vehicle is equipped with a waste water storage and dumping system that will provide adequate and effective
storage and dumping of waste water.Your vehicle should be as level as possible to allow optimal operation of the
system.
CAUTION: Ensure that both the black and grey water gate
valves are closed,(inward position) before using the waste
water system.This applies especially after extensive driving.
Black and grey water dump valves are accessed through the
driver side storage door, (see Picture G-P13).
Waste Water Tank Preparation:
Your vehicle is equipped with two waste water tanks;the
grey waste water tank is for waste water from the sink and
aisle shower.The black waste water tank is for sewage from
the toilet. Both tanks are equipped with separate dump
valves so that each may be dumped independently.Before
use of either waste tank, be sure to read instructions
provided by the toilet manufacturer regarding waste water
chemicals.We suggest that such chemicals be used every
time to minimize odours and build up of solids on water
level sensors inside the tanks.
CAUTION: During winter use under moderate subfreezing
conditions,(refer to page G.1-G.3) antifreeze is required in
the exterior black and grey waste water tank. Antifreeze
should be used at a 50-50 ratio.
Picture G-P14: Access to sewer discharge assembly,
black and grey gate valve handles.
Picture G-P13: Driver side storage door.