Filter
Top Products
Black plate (8,1)
Chevrolet Impala Police Package - 2013 - CRC - 4/10/12
15-8 Special Equipment Options
Auxiliary Battery Power
Junction Blocks
The auxiliary battery power junction
block is mounted in the trunk of your
Impala police vehicle. It is located
on the passenger side support strut
behind the rear wheel housing.
This junction block is split to provide
two circuits and can be used to
connect customer-furnished
equipment directly to the battery
through 8.0 mm² ( 8 gauge) body
wiring and fusible links. A maximum
of 100 amps (1200 watts) can be
connected. Torque the connections
to the studs to 15 N·m (11lb ft). It is
fed by two fusible links of
50 amps each.
To connect the customer-furnished
equipment at the junction block, use
the following steps:
1. Disconnect the negative (−)
battery cable.
2. Connect the customer-furnished
equipment positive leads to the
junction block terminals and
tighten to 15 N·m (11lb ft).
The ignition must be turned off
and the vehicle vacated prior to
connecting the negative (−)
battery cable to the battery.
3. Reconnect the negative (−)
battery cable to the battery.
4. Set the time on the clock and
radio pushbuttons as needed.
See “Audio System” in the
owner manual.