Chevrolet 2010 Equinox Automobile User Manual


 
4-26 Instruments and Controls
Timer
This display can be used as a timer.
To start the timer, press
V or SET/
CLR while Timer is displayed. The
display will show the amount of time
that has passed since the timer was
last reset, not including time the
ignition is off. Time will continue to
be counted as long as the ignition is
on, even if another display is being
shown on the DIC. The timer will
record up to 99 hours, 59 minutes
and 59 seconds (99:59:59) after
which the display will return to zero.
To stop the timer, press
V or SET/
CLR briefly while Timer is displayed.
To reset the timer to zero, press and
hold
V or SET/CLR.
Digital Speedometer
The speedometer shows how fast
the vehicle is moving in either
kilometers per hour (km/h) or miles
per hour (mph). The speedometer
cannot be reset.
Turn-by-Turn
This display is used for the OnStar
or Navigation System Turn-by-Turn
guidance. See OnStar
®
System
on
page 439
or the Navigation
manual, if the vehicle has
navigation, for more information.
Blank Display
This display shows no information.
Vehicle Information Menu
Items
Press the MENU button until Vehicle
Information Menu is displayed. Then
press
x to scroll through the
following menu items:
.
Unit
.
Tire Pressure
.
Remaining Oil Life
.
Blank
Unit
Press
V or SET/CLR to enter the
unit menu. Then press
w or x to
switch between US or Metric when
the Unit display is active. Press
V
or SET/CLR to confirm the setting.
This will change the displays on the
cluster and DIC to either metric or
English (US) measurements.
Tire Pressure
The display will show a vehicle with
the approximate pressures of all
four tires. Tire pressure is displayed
in either pounds per square
inch (psi) or in kilopascal (kPa).
Any time the tire pressures are
adjusted the system needs to
relearn the new pressures. To
relearn the tire pressures press
V or
SET/CLR while the Tire Pressure
display is active. The display will
ask for confirmation of a relearn.
Press
w or x to select Yes or No.
Then press
V or SET/CLR to
confirm the selection. See Tire