Filter
Top Products
3. Say the name tag of the person to call.
• If the system clearly recognizes the name tag it
responds with “OK, calling, <name tag>” and
dials the number.
• If the system is unsure it recognizes the right
name tag, it confirms the name tag followed
by a tone. If the name tag is correct, say “Yes”.
The system responds with “OK, calling,
<name tag>” and dials the number. If the name
tag is not correct, say “No”. The system will
ask for the name tag to be re-entered.
Once connected, the person called will be heard
through the audio speakers.
Using the Re-dial Command
1. Press and hold b g for two seconds. The system
responds with “Ready” followed by a tone.
2. After the tone, say “Re-dial”. The system responds
with “Re-dial using <phone name>” and dials the
last number called from the connected Bluetooth
phone.
Once connected, the person called will be heard
through the audio speakers.
Receiving a Call
When an incoming call is received, the audio system
mutes and a ring tone is heard in the vehicle.
• Press b g and begin speaking to answer the call.
• Press c x to ignore a call.
Call Waiting
Call waiting must be supported on the Bluetooth phone
and enabled by the wireless service carrier to work.
• Press b g to answer an incoming call when
another call is active. The original call is placed
on hold.
• Press b g again to return to the original call.
• To ignore the incoming call, continue with the
original call with no action.
• Press c x to disconnect the current call and
switch to the call on hold.
3-90