Filter
Top Products
yellowblue
6-23
Then, follow these steps:
1. The manual transaxle
dipstick is located below
the brake master
cylinder, near the rear of
the transaxle case. Flip
the handle up and then
pull out the dipstick and
clean it with a rag or
paper towel.
2. Push it back in all the way and remove it.
3. Check both sides of the dipstick and read the lower
level. The fluid level must be between the ADD and
FULL marks. (Note: Fluid may appear at the bottom
of the dipstick even when the fluid level is several
pints low.)
4. If the fluid level is where it should be, push the
dipstick back in all the way and flip the handle
down. If the fluid level is low, add more fluid as
described in the next steps.