Filter
Top Products
3. Setup 8 11/29/2010 4:14 PM
Mounting
Orientation
The COLORrail™
may be mounted in any position provided there is adequate room for
ventilation.
Rigging
Be sure that the structure can support the weight of the fixture. Please see the “Technical
Specifications” section of this manual for a detailed weight listing. Mount the fixture securely. This
may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13 mm
in size. When rigging, consider routine maintenance and control panel access. Please see the
following notes on installation.
• If the power link out is intended to be used with multiple fixture, take into account the
length of each power cable, and mount the fixtures close enough to one another to
accommodate for this.
• When aiming the fixtures, you may use the bracket/yoke adjustment knob(s). Loosen
the knob(s), adjust to the desired angle, and then tighten the knob(s) by turning
clockwise. Do not use tools for this step, as it may cause damage.
• Safety cables must always be used.
There are two (2) rigging options available for this product. If using the mounting
brackets, then you must use both of them. If using the mounting yokes, then it is only
necessary to use a single mounting point.
Mounting Bracket
(1 of 2)
Mounting Yoke
Bracket Adjustment
Knob
Yoke Adjustment
Knob
Mounting Bracket
Yoke Adjustment
Knob