Filter
Top Products
Return to First Car Operation (LCD Remote Only)
1. Press and hold and buttons at the same time until one long beep is
heard. Programming Mode has now been entered.
Note: No action for five seconds will generate two long beeps indicating the
Programming Mode has been exited.
2. Within 5 seconds, press and hold the button until two beeping sounds are
heard and the icon is not displayed on the LCD screen indicating first car
operation.
17
If your transmitters have been programmed to a second Marksman security system, follow the
steps below.
For 1-Way Remote Control Transmitter:
The 1-way backup transmitter does not have the ability to operate 2 systems. Only the 2-way
LCD transmitter can operate 2 different systems.
For LCD Remote Control Transmitter:
Second Vehicle Operation: While the icon is displayed on the LCD screen, you can remote
control and communicate with a second vehicle security system.
1. Press and hold and buttons at the same time until one long beep is heard.
Programming Mode has now been entered.
Note: No action for five seconds will generate two long beeps indicating the
Programming Mode has been exited.
2. Within 5 seconds, press and hold the button until two beeping sounds are
heard and the icon is displayed on the LCD screen indicating second car
operation.
3. While the is displayed, press any button on the transmitter to control the
second vehicle’s security system or alarm function (arm/disarm/trunk/remote start).
Note: Button functions are the same for the second car as they are for the first car.
Second Security System Operation
The LCD remote control is powered by a 1.5 Volt AAA
Alkaline battery. When the power of the battery
weakens, the battery icon will be displayed on the
screen. When the old battery is replaced with a new
one, there will be a beep to indicate the power is up. To
replace the battery, follow the steps in the illustration
at left.
Note: Press the button two times when the battery
compartment is empty, then insert the new battery.
Battery Replacement
(Applies to LCD Transmitter Only)
PLUS6900-UM.qxp 4/30/09 3:48 PM Page 17