Filter
Top Products
Press Buttons at the Same Time: Then Press Button Within: System Function
5 Sec.
Switching to 2nd Vehicle
or Returning to 1st
Vehicle Operation
5 Sec.
Melody / Vibration Mode
5 Sec.
Power Save Mode
LCD Screen Lamp
Turns On for Five Seconds
3 Sec.
System Status Check
3 Sec.
Clear the Flash Icon
and Melody Sound
Programming the LCD Transmitter
6
+
+
+
+
The LCD remote control is powered by a 1.5 Volt
AAA Alkaline battery. When the power of the
battery weakens the battery icon will be
displayed on the screen. When the old battery is
replaced with a new one, there will be a beep to
indicate the power is up. To replace the battery,
follow the steps in the illustration at left.
Note: Press the button two times when the
battery compartment is empty, then insert the
new battery.
+
Battery Replacement
LED Function
OFF System is Disarmed
Slow Flashing System is Armed
Fast Flashing Automatic Arming Timer is Counting Down
LED On Solid System in Valet Mode (Ignition Key On)
1 Flash Every 5 Seconds System in Valet Mode (Ignition Key Off)
2 Flashes - Pause Zone 2, Trigger from Trunk/Hood
3 Flashes - Pause Zone 3, Trigger from Door Switch
4 Flashes - Pause Zone 4, Trigger from Shock Sensor
5 Flashes - Pause Zone 5, Trigger from Ignition Switch
LED Indicator
PLUS-5900-UM.qxp 4/30/09 3:12 PM Page 6