Filter
Top Products
The transmitter can be used as a remote panic switch to manually trigger the alarm system in
case of an emergency.
1. Press and hold the button for 3 seconds to enter the Panic Mode (horn/siren will start to
sound and parking lights will flash).
2. While in Panic Mode the transmitter and buttons can be used to lock and unlock the door
(if that option is installed). However, if the button is pressed, the vehicle’s starter disable
device (when installed) will be disabled, allowing the vehicle to start.
3. To turn off the panic function, press and hold the button again for 3 seconds or press and
release the or buttons.
4. If the panic function is not turned off by the transmitter, it will turn off and reset itself after 30
seconds.
Disarming without a Transmitter
Panic Feature
The override procedure may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to “ON” position (alarm will sound).
2. Within 10 seconds push the valet switch. The alarm will stop sounding and enter disarm Mode.
You can now start and operate the vehicle normally.
6
Manual valet mode allows you to bypass all alarm functions eliminating the need to hand your
transmitter to parking attendants or garage mechanics. This mode is also a necessity if your
transmitters become in-operable. When the system is in Valet Mode, all alarm functions are off.
However, the remote panic feature and remote door locks remain operational. To enter the Manual
Valet Mode, the system must first be disarmed either by using your remote transmitter, or by
operating the manual override sequence.
Enter Valet Mode
1. When in Disarmed Mode, turn the ignition to the “ON” position.
2. Push and hold the valet switch for 2 seconds. The LED will be on solid.
Turn off the igntiion key and the LED will flash every 5 seconds as long as
the unit is in the Valet Mode.
Exit Valet Mode
1. To return to normal operation, turn “ON” ignition (LED will be on solid).
2. Push and hold valet switch for 2 seconds. The LED will be off, indicating the system has now
exited the Valet Mode.
Hold 2 Seconds
Manual Valet Mode
PLUS4900-UM.qxp 4/30/09 2:52 PM Page 7