Filter
Top Products
7
The following is a brief description of the operation of each programmable feature. Any adjustment to the
operation of these features must be performed by the dealer who installed your Carbine Security System. These
features are not user adjustable.
Ignition Key Controlled Door Lock/ Unlock: (Remote door lock/unlock option must be installed)
With this feature activated, the door lock system of the vehicle will become locked 3 seconds after the ignition
key is turned to the on position (All doors). When the ignition key is turned to the off position, the door locks
will immediately become unlocked (All doors).
Note: This feature has 3 modes in which it can operate. Mode #1 operates as explained above and is the
most common operation. Model #2 locks the doors when the ignition key is turned on but does not unlock
the doors when the ignition key is turned off. In mode #3 the ignition key locking feature is off.
Chirp Status Indicator Delete: (Permanent Chirp Delete)
De-activating the chirp indication system will eliminate the arm and disarm chirp indicators. For your safety,
the tamper warning chirp indicator will always be active.
Automatic Arming of Security System:
When the automatic arming of security system feature is programmed on, the security system will
automatically become armed 30 seconds after the last protected entrance is closed without requiring a signal
from the remote transmitter. (Ignition switch must be off)
Automatic Door Locking: (Remote door lock/unlock option must be installed)
If it is desired to have the vehicle’s power door locking system become locked at the same time the security
system becomes armed by the automatic arming of security system feature, the automatic door locking
programming should be on.
Option #5: Starter Disable Relay
Adding option #5 will increase the level of protection that your Carbine security system can offer. When
the starter disable relay is installed, the vehicles engine will not crank when the alarm system is in the
armed mode.
Option #6: Dual Zone Shock Sensor
Installing option #6 will increase the level of security provided by your Carbine security system. Zone #1 of
the dual zone shock sensor will detect lighter non-threatening disturbances that would normally set off most
sensors and trigger the security system. If zone #1 is activated the security system will emit a single chirp
from the horn/siren. This single chirp is a pre-warning if a would be thief is attempting to enter your vehicle.
Zone #2 detects heavier impacts that are considered threatening and immediately triggers your security
system by sounding the horn/siren and flashing the parking lights.
Upgrade Options
Programmable Features:
PLUS4600UM 1/30/02 10:28 AM Page 7