Carbine PLUS-4600 Automobile Alarm User Manual


 
2
Congratulations on your purchase of a quality Carbine Automotive security system. Carbine automotive
security products have been designed to provide the consumer with a product that is technologically
superior and will provide years of trouble free operation.
The information enclosed will provide a ready reference of the operation and maintenance of your new
Carbine security system.
1. Exit the vehicle and close all entrances.
2. Press and release the LOCK button on the transmitter. The security system will respond as follows:
A. The horn/siren will chirp one time.
B. The LED indicator will begin to flash at a steady rate.
C. The parking lights will flash one time.
D. All protected entrances are armed.
Note: If the dome light is on or a sensor is active at the time you arm your security system, You will
hear the horn/siren beep one time and then you will hear another beep from the horn/siren about 5
seconds later. This second beep is the active sensor warning indicator. This second beep tells you that
the alarm is armed but one of the sensors has been temporarily deleted because it was on at the time
the alarm was armed.
The security system is now fully armed!
Your Carbine security system operates from this transmitter shown here. use this drawing as a ready
reference while reading through the operating procedures.
Security System Operation: (Using the transmitter to arm the security system)
Remote Control Transmitters
Lock
Unlock
Panic
2nd Channel
PLUS4600UM 1/30/02 10:28 AM Page 2