Filter
Top Products
ELECTRICAL
ƽ
WARNING
Unless otherwise indicated, al-
ways turn ignition switch to the
OFF position before performing
any maintenance or repair on elec-
trical system.
Spark Plug Removal/
Inspection
vmo2008-008-033_a
TYPICAL — RH SIDE OF VEHICLE
1. Spark plug location
Removal
vmo2008-008-034_a
UNPLUG SPARK PLUG CABLE
1. Spark plug cable
vmo2008-008-035_a
UNSCREW SPARK PLUG ONE TURN
1. Spark plug
Clean spark plug and cylinder head
with pressurized air if possible.
ƽ
WARNING
Always wear safety goggles when
using pressurized air.
Unscrew and remove spark plug com-
pletely.
Installation
Prior to installation make sure that con-
tact surface of cylinder head and spark
plug are free of grime.
Using a feeler gauge, set the spark
plug gap between 0.7 and 0.8 mm
(.027 to .031 in).
Apply anti-seize lubricant over spark
plug threads to prevent a possible
seizure.
Screw spark plug into cylinder head by
hand and tighten with a torque wrench
and proper socket.
Torquesparkplugto11N•m
(97 lbf•in).
_____________________
109