Filter
Top Products
8
© BMW AG, Munich 01 29 0 409 384 04.2006 (Z/Z)
6. To install and connect the wiring harness
Remove the cover (1) from the right of the trunk
and transfer the specified dimensions.
Drill through the cover (1) at the drilling position
(2) using a 3 mm twist drill bit.
Secure control unit B to the cover (1) using
Philips screw I.
Connect the sensor cable (2), branch A1 (black
4-pin) and branch D1 (black 4-pin) to control
unit B.
Install the cover (1) and tie back excess lengths of
the sensor cables (2).
Route branch A2, black cable, to joint connector
X493, brown/black cable, and connect it with
miniature connector Q.
Route branch A3, red cable, to the grommet (1)
on the tailgate bottom section.
Use a multimeter to check whether the
reversing light signal is present on the white/
yellow cable on the grommet.
Use miniature connector Q to connect branch A3
to the white/yellow cable.
Use expanding rivet K to secure signal generator
C to the existing hole in the fuse holder (1).
Route branch D2 (black 2-pin) along the standard
wiring harness to the signal generator C and
connect it.
1
2
103 mm
17 mm
053 0830 Z
1
D1
A1
I
2
B
053 0831 Z
X493
A3
1
A2
Q
053 0832 Z
D2
C
K
1
053 0833 Z