Filter
Top Products
Mobility
223
Reference At a glanceControlsDriving tipsCommunications NavigationEntertainment
High beams
H7 bulb, 55 watts
1. Turn the bulb holder to the left and remove.
2. Remove and replace the bulb.
Parking and roadside parking lamps
In the event of a malfunction, please go to your
BMW center or a workshop that works accord-
ing to BMW repair procedures with correspond-
ingly trained personnel.
Xenon lamps*
The service life of these bulbs is very long and
the probability of a failure is very low, provided
that they are not switched on and off an unusual
number of times. If one of these bulbs should
nevertheless fail, it is possible to continue driv-
ing with great caution using the fog lamps, pro-
vided traffic laws in your area do not prohibit
this.
Have work on the xenon lighting system
performed only by your BMW center or a
workshop that works according to BMW repair
procedures with correspondingly trained per-
sonnel. Due to the high voltage present in the
system, there is a danger of fatal injuries when
work is carried out improperly.<
Access to lamps
The illustration shows the left-hand side of the
engine compartment.
1 Cover cap for parking and roadside parking
lamps, daytime running lamps
2 Sealing cap for turning lamps
*
To remove the covers:
> Parking lamps and roadside parking lamps,
daytime running lamps: turn the cover cap
to the left and remove.
> Turning lamps: turn the sealing cap to the
left and remove.
Parking lamps and roadside parking
lamps, daytime running lamps
H8 bulb, 35 watts
1. Turn the bulb in the direction of the arrow, in
the opposite direction on the other side,
and remove.
2. Remove the connector and replace the
bulb.
Turning lamps*
H3 bulb, 55 watts
Online Edition for Part no. 01 41 2 602 678 - © 08/09 BMW AGOnline Edition for Part no. 01 41 2 602 678 - © 08/09 BMW AG