4. Slide the detector onto the mounting bracket until it
“locks” into place.
5. To adjust the angle of the
bracket, squeeze and hold the
circular “buttons” on the sides
of the bracket; this will allow
you to angle the bracket to
your windshield.
Note—some vehicles have a
plastic coating on the inside
of the windshield designed to
protect occupants in case of
an accident. Use of the
windshield bracket on this type of windshield can
permanently mark the surface. Check with your dealer if you
are unsure whether your vehicle is equipped with this type of
windshield.
Visor Mounting
1. Remove the two suction cups and follow steps
1, 2, 4 and 5.
2. Clip the detector to the edge of the sun visor nearest
the windshield.
Fuse Replacement
If the fuse has blown, remove the tip from the lighter
plug followed by the old fuse. Replace the fuse with a
1-amp, 3AG fuse. Defeating the fuse protection can
damage your unit or your vehicle’s electrical system
and will void your warranty.
Note—the tip is in two pieces; be careful not to lose either
piece or the spring inside the holder. (See diagram below).
18
k
k