Filter
Top Products
Pilot HWY
Pilot H
Voice ON
Voice OFF
PwrOn STD
PwrOn FST
aMute ON
aMute OFF
City STD
City LoX
Bands DFT
Bands MOD
POP
ON or OFF (default is off)
SWS ON or OFF (default is off)
TSR ON or OFF (default is off)
Press the CHANGE button
to change your setting
within a category
* Full word: Highway or City
Letter: H or C
* Voice alerts on
Voice alerts off
* Standard power-on sequence
Fast power-on sequence
* AutoMute on
AutoMute off
* Standard City mode sensitivity
Low X band sensitivity in City Mode
* Factory default settings
Factory default settings modified
Turn bands “ON” or “OFF” by
pressing the VOLUME•MUTE button
Press the REVIEW button
to go from one
category to the next
PILOT
(Power-on indication)
VOICE
POWER-ON SEQUENCE
AUTOMUTE
CITY MODE SENSITIVITY
BANDS
* Factory Default Settings
To reset your V6 to its original
factory settings, press and hold
the “CITY” and “BRT” buttons
while turning the power on. The
V6’s display will provide a
Reset message, accompanied
by an audible alert,
acknowledging the reset.
Pilot (Power-on indication)
NOTE: When you are using the
Dark mode, the display will only show
HD or CD (Highway-Dark or City-
Dark).
Pilot HWY (Full description)
In this setting, your V6 will display
“Highway” or “City” as its power-on
indication. (factory default)
Pilot H (Letter)
In this setting, your V6 will display “H” for
Highway and “C” for City.
Voice
Voice On (Voice announcements on)
In this setting, all radar, laser, and SWS
messages (if programmed) will be
announced using a digital voice.
Voice Off (Voice announcements off)
In this setting, only the distinct audio tone
will be heard when a radar, Laser, or SWS
message is detected.
Power-on Sequence
PwrOnSTD (Standard)
In this setting, each time you turn on your
V6, it will display “BEL V6,” “Laser,” “Ka-band,”
“K-band,” “X-band,” “Safety,” followed by a
brief X-band alert. (factory default)
If any bands have been changed from
the factory default settings, a double X-band
tone and corresponding message
(i.e. “SWS ON”), will alert you that one or
more bands have been changed.
PwrOnFST (Fast power-on)
In this setting, your V6 will provide a single
X-band tone. If any bands have been
changed from the factory default settings, a
double X-band tone and corresponding
message (i.e. “SWS ON”), will alert you that
one or more bands have been changed.
AutoMute
aMute ON (AutoMute on)
In this setting, your V6’s audio alerts will
initially be at the volume you set, but after a
few seconds, the V6 will automatically
reduce the volume level, to keep you
informed, but not annoyed. (factory default)
aMuteOFF (AutoMute off)
With AutoMute off, your V6’s audio alerts
will remain at the volume you set for the
duration of the radar encounter.
12 13
Overview of Programming Details of Programming