Filter
Top Products
© 2010 Baja, Inc. All Rights Reserved.
MAINTENANCE
CLUTCH MAINTENANCE
lubrication. If the clutch becomes too dirty or lacks lubrication,
the clutch will begin to stick, which could cause the mini bike
To clean and lubricate the clutch:
Turn engine off and allow to cool completely.
Add a few drops of 30W motor oil to the clutch bearing to
lubricate. Do not allow oil to get inside the clutch itself.
through bearing surface.
WARNING:
serious personal injury.
CLEANING
A thorough cleaning of the mini bike is a necessary part
of maintenance. It will help keep the mini bike looking and
performing at its best. Proper cleaning can also extend the
life of the mini bike.
especially on the engine and exhaust system, can reduce
engine cooling ability, conceal damage, or increase wear of
The mini bike should be washed before any mud dries on
NOTE: Do not use high pressure washers such as those
found at car washes. They could cause mechanical, electri
cal and other damage.
Hand wash the unit with mild soap or detergent and wa
cleaning brushes can be used, but be careful with brushes
as they can scratch plastic or painted surfaces.
Rinse the unit thoroughly with clean water.
Dry all areas using a chamois or soft absorbent cloth or
allow the unit to air dry.
Lubricate the chain and run the engine at idling speed for
a few minutes.
Follow the procedures in Pre-Ride Inspection to check
your last ride.
After washing your mini bike, test your brakes by riding at
let the friction dry out the brake linings. Wet brakes may
WARNING:
Operating the mini bike at high speeds when the brakes
are wet could result in serious personal injury.
CLUTCH
COVER
CLUTCH
BEARING