Avital 3001 Remote Starter User Manual


 
User-Programmable Temperature-Controlled Starting
I
CAUTION : Do not activate Temperature-Controlled Starting while
the vehicle is in an enclosed area.
The AviStart system can be programmed to monitor the air temperature inside
your vehicle and automatically start the vehicle engine whenever the
temperature inside reaches or drops below a preprogrammed temperature
level. There are three temperature levels to choose from. (This feature is
programmed OFF from the factory and must be programmed ON to operate.
See the "Programming Table for System Features"on page 9.)
To Activate
Press the remote control
s
and
C
buttons at the same time for 1-2 seconds.
The parking lights will turn on for 3 seconds, turn off for 1 second, turn on for
3 seconds and then shut off. This will be your visual indication that you have
activated the Temperature-Controlled Starting feature.
The AviStart will monitor the air temperature every 2.5 hours and will only
start the engine if the temperature inside the vehicle has reached or dropped
below the preprogrammed temperature level. The parking lights will flash 2
times, the vehicle will start and the parking lights will turn on. The vehicle will
run for 10 minutes and then shut off. This will allow the engine to warm up
and charge the battery.
To Deactivate
Press the remote control
s
and
C
buttons at the same time for 1-2 seconds.
The parking lights will turn on for 3 seconds and then shut off. This will be
your visual indication that you have deactivated the Temperature- Controlled
Starting feature.
NOTE: At any time, if the ignition key is turned "ON" or the vehicle is remote
started, the Temperature-Controlled Starting feature will deactivate.
Pit Stop Mode
I
CAUTION : Do not leave passengers or pets in the vehicle while the
system is in Pit Stop Mode.
The Pit Stop Mode allows you to park the vehicle for short-term stops, remove
the ignition key and leave the engine running.
6
AviStart 3001 Owner's Manual