Filter
Top Products
GPS-DG9208G3 | Vehicle Specifi c Mounting Bracket for Most Portable GPS
!
Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and / or
air bag deployment.
Arkon is not responsible for any damages caused to your car, your
device, or yourself due to the installation or use of this pedestal mount.
The Mobile Mounting Specialists™
Consumer Hotline:
USA (800) 841-0884
INT’L (626) 254-9005
Monday - Friday 9 am - 5 pm, PST
www.arkon.com
Arcadia, CA 91006 USA
Designed in USA | Made in the USA & China
© Copyright 2010 Arkon Resources, Inc.
Step 1.
Step 1.
Step 1.
Step 2.
Connect TomTom Device to Pedestal with EasyPort™ pattern
Connect TomTom Start™ & Ease™ Device to Pedestal
Connect Garmin Device to 17mm ball head
While holding the mounted TomTom adapter plate, gently
insert the TomTom device (not included, sold separately) into
the adapter plate until an audible click is heard. The device
can then be rotated into the desired viewing angle.
Slide the adapter plate up into the grooves on the back of the
TomTom GO series device (not included, sold separately).
Step 1.
Step 1.
Connect TomTom GO GPS to Pedestal
Connect Adapter Plate for TomTom GO GPS
While holding the mounted TomTom adapter plate, gently insert
the TomTom device (not included, sold separately) into the
adapter plate until an audible click is heard.
Attach the dual-T adapter plate for TomTom to the pedestal by
inserting the dual-T tabs of the pedestal (A) into the dual T-slots
on the adapter plate (B).
Attach Garmin GPS to 17mm ball head by fi rmly pushing the
ball head (A) into the 17mm ball head socket on the back of the
device (B) as pictured below.
Step 1.
Connect Adapter Plate for TomTom EasyPort™ to Pedestal
A
B
B
A
B
A
A
B
A
B
D
C
Step 1.
Connect Mio Moov 200 Series or NAVMAN 530 3D GPS Device
to Pedestal
Connect the adapter plate for Mio Moov to Mio device (not
included, sold separately) by placing the feet (A) of the adapter
into the corresponding notches (B) on the bottom of the device.
Holding the thumb tab down (C), insert the upper tooth (D) into
the recessed slot on the back of the device.
Connect the dual T-tabs (A) on the dual-T pedestal to the dual
T-tab slots (B) on the adapter plate.
Connect the dual T-tabs (A) on the dual-T pedestal to the dual
T-tab slots (B) on the adapter plate.