Filter
Top Products
P. 6 User Guide
The L.E.D. will come ON solid once the ignition key is removed.
To take the system o u t o f Valet Mode:
• Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION ON / RUN and OFF positions.
• The parking lights will flash twice to indicate that the vehicle is now in Valet Mode.
The L.E.D. will go out.
Note: With the Ignition Valet activated, the remote starter and the alarm functions will be
disabled.
Remote Valet Mode
This feature will allow you to remotely put your system into Valet Mode by using the transmitter
instead of the Valet button as above.
Getting into Valet Mode
• Hold the UNLOCK and START/STOP buttons simultaneously for 3 second.
• The Parking Lights will flash 3 times.
The LED will remain on solid.
Getting out of Valet Mode
• Hold the UNLOCK and START/STOP buttons simultaneously for 3 second.
• The Parking Lights will flash 2 times.
The LED will turn off.
Note: With the Remote Valet activated, the remote starter and the alarm functions will be
disabled.
Panic Mode
Note: Panic mode can only be activated if the horn has been adequately configured by your
installer.
In an emergency situation, you can activate panic mode by pressing and holding the SHIFT button
for 3 seconds. If the vehicle is under a remote start, you can shutdown the engine, stop the horn
and lock your doors by pressing the
LOCK button:
Furthermore, the panic mode can be stop by activating one of the following three (3) features:
a) Remote valet (pressing
UNLOCK and START/STOP for 3 seconds)
b) Ignition valet (turning the key inside the ignition switch from OFF to ON 5 times in a row)
c) By pressing the valet switch (if included).
Panic Mode will automatically shut down after 25 sec.
Quick Lockout™
(Also called Secure Panic.) For fast protection in emergency situations, the system will LOCK all
doors when you press the brake pedal while you hear the sound signal. (Quick Lockout is
only available when Panic Mode has been set off.)
Cold Weather Mode
When Cold Weather Mode is active, the engine starts every 2 hours and runs for 3 minutes (or for
8 or 20 minutes with diesel engines). The System must be in Ready Mode in order to enter
Cold Weather Mode. Cold Weather Mode automatically ends after 24 hours.
To enter Cold Weather Mode:
• Press the SHIFT button and then press and hold the START/STOP button for 3 seconds until the
parking lights flash three times.
To exit Cold Weather Mode, do any one of the following actions:
• Open the hood.
• Start the engine by remote.
• Turn the ignition key to the IGNITION ON (RUN) position.