Autostart AS-2350vTW-FM Remote Starter User Manual


 
User Guide P. 15
Diagnostics – Parking Light Flash Table
Flashes Description
1
Doors locked, starter kill armed.
Run time has expired.
TRUNK button pressed.
Start signal received by the module.
Cold weather mode cancelled.
2
Remote start attempt cancelled by remote.
Doors unlocked, starter kill disarmed.
Exiting ignition valet.
Exiting remote valet.
Power-up reset
Board set from manual to automatic; power
ON.
Power
ON to OFF (automatic
transmission).
2 slow flashes then
8 quick flashes
Reset from manual to automatic
3
Entering ignition valet.
Entering or exiting Ready Mode
Entering remote valet.
Entering extended run time
4
+12 V detected on the brake input wire either while cranking or during run time.
Entering multi-speed tach programming.
Entering time delay adjustment in virtual tach system
Board set from automatic to manual; power
ON.
Power
ON to OFF (manual transmission).
5 Fast
Tach signal programmed
New transmitter programmed
6
A remote start was attempted while a tach-before-crank signal was detected before cranking.
8
Unit reset: occurs when the unit is reset to the factory defaults.
10
A ground (-) signal was detected on the hood pin input wire.
When pressing
START/STOP
15 quick flashes…
The parking brake is connected to ground (automatic transmission).
1 – pause – 2
There was a remote start attempt while the vehicle was in valet mode.
Failed start: vehicle’s low battery voltage.
…followed by 1 flash Exiting cold weather mode
ON SOLID for 3
seconds….
…followed by 3 flashes Entering cold weather mode
ON continuously
Idle mode: Idle mode is engaged
Run time: The vehicle has been remote started and is in run time.
ON 2 seconds
The hood has been opened and a ground (-) signal has been detected on the hood pin input
wire.
ON 4 seconds
Locking or unlocking a door (with Door pulses configured to 4 sec.)
ON 20 seconds
The hood pin has been flashed and you are now in the programming centre.
Constant flashes
for 25 sec.
Panic Mode is triggered.