Filter
Top Products
P. 6 User Guide
1. Ensure that the doors are all closed and that the gearshift lever is in the NEUTRAL
position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. push LOCK, UNLOCK or START on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press the TRUNK button until the system is armed (the doors will be locked if remote
door lock is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote control, the
vehicle will get in Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet Mode
When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.
Ignition Valet
This feature will allow you to remotely put your system into Valet Mode by using the ignition key
instead of the Valet button as above. Ignition Valet can be used without a Valet button installed.
To put the system i n t o Valet Mode:
Insert the ignition key into the ignition switch. Within 10 sec.,
turn the key 5 times successively into the IGNITION ON / RUN and OFF positions.
The parking lights will flash three times to indicate that the vehicle is now in Valet Mode.
The LED on the antenna will come ON solid.
To take the system o u t o f Valet Mode:
Insert the ignition key into the ignition switch. Within 10 sec.,
turn the key 5 times successively into the IGNITION ON / RUN and OFF positions.
The parking lights will flash twice to indicate that the vehicle is now in Valet Mode.
The LED on the antenna will go out.
Note: With the Remote Valet activated, the remote starter and alarm functions will be disabled.
Remote Valet Mode
This feature will allow you to remotely put your system into Valet Mode by using the transmitter
instead of the Valet button as above.
Getting into Valet Mode
• Hold the UNLOCK and START buttons simultaneously for 3 second.
• The Parking Lights will flash 3 times.
The LED on the antenna will remain on solid.
Getting out of Valet Mode
• Hold the UNLOCK and START buttons simultaneously for 3 second.
• The Parking Lights will flash 2 times.
The LED on the antenna will turn off.
Panic Mode
Note: Panic Mode can only be activated if the horn has been adequately configured by your
installer.