Filter
Top Products
P. 10 User Guide
2. Remove the ignition key from the ignition switch.
The engine will go on running.
3. Exit the vehicle and close the door.
Press the TRUNK button to lock the doors; the engine will shut down after
60 seconds of Turbo Mode.
If your vehicle has a manual transmission, follow all steps of the Ready Mode routine, to
activate Turbo Mode:
1. Ensure that all the doors are closed and that the shifter is in the Neutral position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. press LOCK, UNLOCK or START on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
a. LOCK to lock the doors and shut down the engine after 60 sec.;
b. UNLOCK to unlock the doors and shut down the engine after 60 sec.;
c. START to shut down the engine immediately, without affecting the doors
(this will by-pass Turbo Mode).
D. TRUNK TO SET THE VEHICLE INTO IDLE MODE
Engine Run Time
If you have a gas engine, your Remote Car Starter can be programmed to run the engine for 3, 15,
or 25 minutes (15 minutes by default). If you have a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).
Constant While Pressed:
If enabled and if your vehicle is compatible, this option allows you to open or close your windows at
a distance, open or close the sunroof or even to open or close a sliding door:
• Pressing and holding the
LOCK button for more than 3 seconds will lock all doors and will send a
constant pulse as long as the
LOCK button is held down (maximum of 15 seconds). This
constant pulse can be configured to activate certain functionalities such as rolling up the
windows – Please refer to your installer to see if your vehicle is compatible with this
option.
• Pressing and holding the UNLOCK button for more than 3 seconds will unlock all doors and will
send a constant pulse as long as the
UNLOCK button is held down (maximum of 15 seconds).
This constant pulse can be configured to activate certain functionalities such as rolling down the
windows – Please refer to your installer to see if your vehicle is compatible with this
option.
Car Finder
When enabled, the Car Finder option will help you locate your vehicle by generating a pulsating
signal through the horn or the siren. To hear the signal, press
LOCK and UNLOCK simultaneously.
This will cause one chirp and one flash of the lights every time you repeat the sequence.
Flashing LED
The user may decide to turn on or off LED on the antenna flashing at any moment. To do so,
simultaneously press the
TRUNK and LOCK buttons on the transmitter:
Flashing LED ON: the L.E.D. will flash under active arming to indicate that the Starter Kill is active.
Active Arming: the LED will flash normally.
Passive Arming: the LED will not flash during the countdown preceding the
activation of the Starter Kill. Once the Remote Car Starter is armed, the LED will flash at a